Kohler K-8549-SN Guide d'installation télécharger pdf (Page 6)

4. Complete the Diverter Installation

CAUTION: Risk of product damage. Verify that the diverter

body is secure before removing the cartridge. If not secured, the

process of removing the cartridge may damage the pipe and

connections.

CAUTION: Risk of product damage. Excessive heat will damage

the internal plastic components. Do not apply excessive heat

while soldering. Direct the torch ﬂame away from the brass

body. Only apply direct heat to the connectors and extensions.

IMPORTANT! If there is limited access to the solder connections, or

if any other risk of excessive heat being applied to the brass body

exists, remove the cartridge prior to soldering. If you remove the

cartridge, protect the seals and O-rings from becoming dirty,

damaged, or misaligned.

If not already removed, remove the diverter cartridge assembly.

Dry ﬁt all piping and connectors.

Solder piping for the optional spout or wall shower.

Connect the hot and cold lines from the valves to the diverter.

While supporting from below, carefully install and wrench tighten

the cartridge assembly into the diverter body.

Install the diverter handle. Use a hex wrench to tighten the

setscrew.

Note: Provide Diverter Support

Diverter

Valve Body

Diverter

Cartridge

Escutcheon

Deck/Rim

Setscrew

Stem

Escutcheon

Diverter Handle

1000588-2-C 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Pas de commentaire

Kohler K-8549-SN Guide d'installation Page 6