Kohler K-705704-L-NX Guide d'installation télécharger pdf (Page 10)

5. Install the Bottom Bracket

NOTE: There is a label on the side lite panel identifying the ″non-coated side″ of the panel. The

non-coated side of the panel should face the outside of the shower when bottom bracket is being installed.

Place a bushing in the lower hole in the side lite panel where the bottom ﬁxed hinge will be

installed.

Place the gasket on the lower corner of the glass, aligning the hole in the gasket with the hole in the

glass.

Gently slide the bottom ﬁxed hinge over the gasket, aligning the hole in the bracket with the hole in

the glass.

Insert the supplied screw into the side of the bottom ﬁxed hinge and fasten.

Tighten the screw until is it snug and/or ﬂush with the surface. Do not overtighten.

Side Lite

Screw

Bottom Fixed Hinge

Gasket

To Inside

of Shower

Bushing

1064866-2-B 10 Kohler Co.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Pas de commentaire

Kohler K-705704-L-NX Guide d'installation Page 10