Kohler K-10087-9-CP Guide d'installation télécharger pdf (Page 5)

2. Complete the Valve Installation

If you have not already done so, install supply stops.

Install copper tubing between the valves and the supply stops.

Temporarily pull the plaster guards from the handle shanks and

spout shank. Do not discard them at this time.

Position a bucket in front of the spout shank, then open the water

supplies and the valves.

Close the valves and the water supplies, then carefully inspect all

connections for leakage. Repair if necessary.

Turn off the water supplies. Open the valve stems to relieve the

water pressure.

Reattach the plaster guards.

3. Finish the Wall

NOTE: To ensure proper ﬁt and appearance, do not oversize the

holes for the handle shanks and spout shank.

Complete the ﬁnished wall with three 1-1/2″ (3.5 cm) diameter

holes for the spout and handle shanks. Space the hole centers 4″

(10.2 cm) apart.

Remove and discard the plaster guards when the ﬁnished wall is

complete.

1-1/2"

(3.8 cm) D.

Finished

Wall

Plaster

Guards

Handle

Shank

Spout

Shank

Plaster Guards

1/2" Cold

Supply

Handle

Shank

1/2" Hot

Supply

4" (10.2 cm)

Kohler Co. 5 1139731-2-A

1 2 3 4 5 6 7 8 9 10 ... 23 24

Pas de commentaire

Kohler K-10087-9-CP Guide d'installation Page 5