Kohler Freewill Barier Free Bath Whirlpools K-12106-H Manuel d'utilisateur télécharger pdf (Page 12)

115982-2-BA (-)

Kohler Co., Kohler, WI

8. ELECTRICAL CONNECTIONS

A. IDENTIFY ELECTRICAL REQUIREMENTS

The model number is printed on a label at the pump end

of the whirlpool.

The label identifies electrical rating.

B. WIRING INFORMATION – 120 V, 60 HZ –

2-SPEED PUMP (UL LISTED) MODELS

WARNING: Risk of electrical shock. To reduce

the risk of electric shock, connect only to a properly

grounded, grounding-type receptacle, protected

by a Ground-Fault Circuit-Interrupter (GFCI). Do

not remove the plug’s grounding pin. Do not use a

grounding adapter.

Your Kohler whirlpool bath is equipped with a cord and

plug. All wiring of the pump and control has been

completed at the factory. A licensed electrician must

install a GFCI-protected, 120 V, 20 A, grounded outlet.

Your whirlpool may then be plugged into this outlet. No

other load should be on this circuit. Locate the outlet

behind the whirlpool, and within 24” of the pump.

* For bonding in accordance with national and local

codes.

Switch

Wire

Bonding

(Earthing) Lug*

Pump

Plug-in

Cord

20 A

Receptacle

Control Box

9. WATER TEST WHIRLPOOL AND ELECTRONICS

Check all electrical connections.

Make sure all pipe connections to the pump are securely

tightened.

Fill the whirlpool to a level at least 2” above the top of the

highest jet.

Operate the whirlpool for 5 minutes, and check all

whirlpool harness (piping) connections for leaks.

For additional information on whirlpool operation, see

Start-Up Whirlpool instructions on Page 14.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Kohler Freewill Barier Free Bath Whirlpools K-12106-H Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement pour l'eau Kohler Freewill Barier Free Bath Whirlpools K-12106-H