Kohler K-1663-G Guide d'installation télécharger pdf (Page 3)

1. Prepare the Site

NOTE: Follow the instructions packed with your steam head and control panel kit.

NOTICE: The steam head must be installed at least 6″ (15.2 cm) from the ﬂoor in an area where contact

with occupants is unlikely.

NOTICE: Provide clearance between the back wall and the elbow. The elbow should not contact the back

wall.

NOTE: The edge of the hole should be at least 1″ (2.5 cm) away from all wall studs.

Drill a 2-1/2″ (6.4 cm) diameter hole in the wall at the desired steam head location.

NOTE: For all the connections, use thread sealant tape and do not overtighten the ﬁttings.

Install a 1/2″ NPT connection on the end of the steam housing assembly.

Secure the connection to the framing whenever possible.

NOTE: The steam generator(s) will not operate without water and a connected user interface control.

6" (15.2 cm) from Floor

4" (10.2 cm)

Min

Provide clearance

from wall.

Wall Stud

2-1/2" (6.4 cm)

1" (2.5 cm) Min

Kohler Co. 3 1008020-2-E

1 2 3 4 5 6 7 8 ... 23 24

Pas de commentaire

Kohler K-1663-G Guide d'installation Page 3