Kohler 4737-0 Guide d'installation télécharger pdf (Page 6)

4. Install the Seat

For All Installations

Slide the seat onto the mounting plate until you feel it snap into

place. Verify the seat is properly aligned.

NOTE: Threaded insert alignment: Remove the seat by pressing in

the release button and sliding the seat forward. Reposition the

mounting plate and seat, then reinstall the seat. Repeat this

procedure until the seat is properly aligned.

NOTE: All other alignment: With the seat still on the toilet, loosen

the nuts on the underside of the toilet. Reposition the seat, then

retighten the nuts. If the nuts cannot be loosened or tightened, it is

likely that the washers are in positioned incorrectly, allowing the

bolt to spin. Refer to the ″Install Mounting Plate″ section for proper

positioning of the washer.

For Toilets with Threaded Inserts

Remove the seat.

Using a ﬂat-blade screwdriver, tighten the bolts to secure the

mounting plate.

Reinstall the seat.

For All Other Installations

Using an adjustable wrench, fully tighten the nuts.

EAR

Release Button

Mounting Plate

1097712-2-A 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Pas de commentaire

Kohler 4737-0 Guide d'installation Page 6