Kohler K-1418-HE-96 Guide d'installation télécharger pdf (Page 8)

4. Mount the Pump

Remove all protective packaging from around the whirlpool harness.

Cut only the cable ties supporting the harness attachment nuts.

Remove the plugs from the pump inlet and outlet connections.

Install the supplied gasket in the connection between the heater and pump.

Install the supplied O-rings/gaskets into the grooves on the inlet and outlet connector.

Position the pump and control. Make sure the rubber isolation feet remain in place.

NOTE: The pump should rest on the same subﬂoor, at the same level as the whirlpool feet. Shim the

pump if necessary on the subﬂoor, but make sure the rubber isolation feet are in contact with the ﬂoor.

The pump should only be high enough to allow water to drain out of the suction line when the whirlpool

is emptied.

IMPORTANT! Do not shim the pump more than 1/4″ (6 mm). Raising the pump too high will prevent

the pump from priming properly.

Thread the plastic inlet and outlet nuts onto the pump and heater until the O-rings and gaskets

make initial contact.

Tighten each nut no more than another quarter of a turn. Do not use a wrench or overtighten these

nuts, as damage or leaks may result.

Make sure the whirlpool inlet piping is pitched down and away from the pump.

If your heater was already installed in the custom location, plug the heater cord into the heater

connection on the control by aligning the pins and pressing it into place.

Locate the solid copper 8 gauge bonding wire on the bracket the pump has shipped on.

Route the bonding wire back to the pump and control and connect to one of the open bonding lugs

on the control box.

Conﬁrm the user keypad wiring is connected to the wiring harness on the control. Connect the

wiring if needed.

User

Keypad

Water intake

pipe must be

pitched down.

Install gasket where

heater and pump join.

Wiring

Harness

Heater Connection

Relocate Pump

Install O-rings

and/or gaskets

(supplied) into

the grooves of

the connector

fittings.

Remove the plugs from the inlet

and outlet piping.

Provide access to the

pump for servicing.

Correct

Incorrect

1194658-2-A 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Kohler K-1418-HE-96 Guide d'installation Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Chauffages d'appoint Kohler K-1418-HE-96