Kohler 12RESM1 Manuel d'utilisateur télécharger pdf (Page 25)

TP-6516 4/09 25Section 1 Installation

Note: The generator set will not start and circuit board

damage may occur if the battery is connected in

reverse.

Figure 1-22 shows the location of the engine starting

battery. Standard battery cables provide easy

connection to the battery. Use the following procedure

to install and connect the battery.

ADV-7341A-B

1. Engine starting battery location

Figure 1-22 Battery Location, Air Intake End

Battery Installation Procedure

1. Ensure that the starting battery is fully charged

before placing the battery in service.

2. Clean the battery posts and/or adapters if

necessary.

3. Install the battery post adapters, if needed.

4. Place the battery in the housing.

5. Verify that the controller master switch is in the OFF

position.

6. Connect the positive (+) lead to the engine starting

battery.

7. Connect the negative (--) lead to the engine starting

battery.

Refer to the generator set Operation Manual and the

battery manufacturer’s instructions for battery

maintenance instructions.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Pas de commentaire

Kohler 12RESM1 Manuel d'utilisateur Page 25