Kohler K-1394-H2-96 Guide d'installation télécharger pdf (Page 6)

3. Secure the Whirlpool to the Subﬂoor

NOTICE: Do not lift the whirlpool by the piping or pumps, or use the piping or pumps for structural

support of the whirlpool.

Choose the installation option that best applies to your particular installation. Follow the

appropriate instructions.

If the subﬂoor is not level, shim the whirlpool support blocks as necessary.

Option for Using a Cement or Mortar Bed

NOTE: Do not use gypsum cement or drywall compound for this application, as they will not provide an

acceptable, durable bond.

Spread a 2” (51 mm) thick layer of cement or mortar on the subﬂoor where the whirlpool will be

set. This will help secure, level, and support the unit. Clear all the material away from the pump

control locations.

NOTE: The pump controls (when the pump banding straps are cut) must rest directly on the subﬂoor.

With help, carefully lift the whirlpool into place, and make sure the pump controls do not rest in

the bed material.

Insert the drain tailpiece into the trap. Make sure the whirlpool is level and resting on all support

blocks.

Option for Using Construction Adhesive

Apply a generous amount of high-quality construction adhesive to the bottom of the support blocks.

With help, carefully lift the whirlpool into position.

Insert the drain tailpiece into the trap. Make sure the whirlpool is level and resting on all support

blocks.

Spread a 2" (51 mm) layer of

mortar cement.

Apply construction

adhesive to the support

blocks.

1022205-2-D 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 55 56

Pas de commentaire

Kohler K-1394-H2-96 Guide d'installation Page 6