Kohler K-702202-L-SHP Guide d'installation télécharger pdf (Page 13)

7. Install the Towel Bar

NOTE: Installation of the towel bar is easiest with two people.

Insert one end of the towel bar into a support; the ﬂat side of the towel bar should be toward the

setscrew.

Slide a washer onto one of the screws with the ﬂat side of the washer facing the head of the screw.

Insert the screw through the mounting hole in the glass.

Slide a second washer onto the screw with the ﬂat side facing away from the glass.

While one person holds the other end of the towel bar, position a support over the screw.

Loosely thread the screw into the support.

IMPORTANT! Do not overtighten the screws. The glass may break.

Fully tighten both screws by inserting a 5/64″ hex wrench into the hole in the screw head. Do not

overtighten.

Repeat for the second support.

Make sure the collars on the washers ﬁt into the holes in the glass.

Washers

1/4" x 20 Screw

Support

5/64" Hex

Wrench

Position flat

side down.

Towel Bar

Setscrew

Kohler Co. 13 1054857-2-B

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Pas de commentaire

Kohler K-702202-L-SHP Guide d'installation Page 13