Kohler K-1151-LA-0 Guide d'installation télécharger pdf (Page 11)

12. Conﬁrm Proper Operation

Fill the Whirlpool

NOTE: Please read these steps carefully before you operate your whirlpool.

Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully

counterclockwise.

Fill the whirlpool to a water level at least 2″ (5.1 cm) above the top of the highest jet.

NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C).

To service oriﬁces insert a pencil into the end of the jet nozzle and push the oriﬁce out. After

removing any blockage, check the oriﬁce to make sure it is clear and press it into the jet housing.

NOTE: Oriﬁces are only installed in whirlpool jets when there are six or more jets in the whirlpool system.

Operating Sequence

Press the air actuator to turn on the whirlpool jets.

Adjust each jet for optimum air/water mixture. Turn the trim ring clockwise to reduce the air ﬂow,

and counterclockwise to increase the air ﬂow.

If equipped with a heater, the heater will engage automatically when the pump is turned on and

will disengage when the pump is turned off. The heater will not turn on if the water temperature

exceeds 104°F (40°C).

Press the air actuator a second time to turn off the whirlpool.

Fill with water at least 2" (5.1 cm)

above the highest jet.

Turn the jet trim ring

clockwise to

decrease the flow.

Position the jet

nozzles to direct

the water flow as

desired.

Turn the jet trim ring counterclockwise

to increase the flow.

Press the air actuator to turn

on and off the whirlpool.

Kohler Co. 11 1012295-2-E

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Pas de commentaire

Kohler K-1151-LA-0 Guide d'installation Page 11