Kohler K-3901-0 Guide d'installation télécharger pdf (Page 12)

Determine the Mounting Block Location (cont.)

Measure dimension ″C″ on the template, starting at the inside line.

Position a mounting block in the area indicated on the left side of the template. Align the outside

edge of the mounting blocks with the inside line.

Insert a pencil into each of the four pre-drilled holes in the mounting blocks and mark the center of

the holes.

Remove the mounting blocks.

At the four locations where the centerline in the slots marked on the template and the pencil mark

indicating the hole locations meet, drill a 3/16″ pilot hole or 1/2″ (13 mm) hole if anchors will be

used.

If anchors will be used, insert one of the supplied anchors in each of the holes.

Remove the template.

1212876-2-B 12 Kohler Co.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Pas de commentaire

Kohler K-3901-0 Guide d'installation Page 12