Kohler 13ERG Manuel d'utilisateur télécharger pdf (Page 45)

TP-6335 9/04 Reconnection/Adjustments 35

To set the engine data input type.

To enter battery voltage selection mode.

To toggle between 12 and 24 VDC.

To enter communications selection mode.

To set the communications parameter.

To enter SAVE mode. Go to Figure 8-11.

E d 0 x

Pressing the up arrow key at the Adnc display (See Figure 8-9) puts you into

the Advanced Configuration Mode.

Press:

B t 1 2

C n 0 x

S A V E

Note: Shaded boxes show which number in the controller display changes when the up or down arrow

keyispressed. “x” denotes any number from 0 to 9.

Note: Be sure to save your settings before exiting the configuration mode. The controller reverts to the

last saved settings when the master switch is moved to the OFF/RESET position.

Figure 8-10 Advanced Configuration Mode (engine data input types, battery voltage, and engine

communications)

To save changes.

To discard changes without saving.

* x in the runtime hours display above denotes any number from 0 to 9.

S A V E

Y E S

Now move the master switch to OFF/RESET.

n o

There are 3 options when the display says SAVE:

Press:

x x xx

To return to the first parameter, system voltage/frequency

Uu, to check or change settings before saving. See

Figure 8-9.

U u 0 x

“Yes”or “no” flashes when the up or down arrow is pressed and then

the controller exits the configuration mode. The display returns to

the runtime hours.

Figure 8-11 Save Mode (after configuring generator set parameters)

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51 52

Pas de commentaire

Kohler 13ERG Manuel d'utilisateur Page 45