Kohler CV1000 Manuel d'utilisateur télécharger pdf (Page 105)

Section 9

Inspection and Reconditioning

9.13

O-Ring

4. Install the O-Ring in the groove of the oil pump

housing. Use a small quantity of grease to hold it

in place. See Figure 9-16.

Figure 9-16. O-Ring Installed in Oil Pump Housing.

5. Lightly lubricate the I.D. of the inlet seal with

oil and carefully insert the end of the pickup

through the seal, into the oil pump housing.

6. Install the oil pump housing with the pickup

tube, over the oil pump boss and gears. Position

ȱȱȱĝȱȱȱŘȱȱřǯȱȱȱ

three screw hole locations.

Figure 9-17. Installing Oil Pump and Pickup.

7. Check the alignment of parts and torque the

ȱȱȱȱȱęȱȱȱ

ȱȱȱȱşȬŗŞǯ

ȱ ȱ ȱȱ¡ǯȱĚȱȱȱǱ

a. Install fastener into location No. 1 and

lightly tighten to position the pump.

b. Install fastener into location No. 2 and fully

torque to the recommended value.

c. Install fastener into location No. 3 and fully

torque to the recommended value.

d. Finish torquing fastener in location No. 1

to the recommended value.

First Time Installation: 10.7 N·m (95 in. lb.)

All Reinstallations: 6.7 N·m (60 in. lb.)

Figure 9-18. Oil Pump Screws Torque Sequence.

ȱ Şǯȱ ȱȱȱȱȱȱȱȱ

10.7 N·m (95 in. lb.) into a new hole, or 7.3 N·m

(65 in. lb.) into a used hole. See Figure 9-17.

Mounting

Screws

Pickup

Oil

Pump

%DIÀH

(Covering

Relief

Valve)

Pickup

Mounting

Screw

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 137 138

Commentaires sur ces manuels

Pas de commentaire

Kohler CV1000 Manuel d'utilisateur Page 105

Commentaires sur ces manuels

Produits connexes et manuels pour Moteur Kohler CV1000